08-Sep-2017, 11:03
(This post was last modified: 08-Sep-2017, 11:23 by audio_engr.)
Need a bit of advise from you guys out here ...
Ideally ...
Scenario - 1 : Take 110 ohms AES/EBU cable, terminate Destination Male XLR with Pin1 = Gnd; Pin2 = +ve; Pin3 = -ve and Source RCA with Centre = +ve; Body = Gnd and -ve
OR
Scenario - 2 : Take 75 ohms S/pDIF cable, terminate Destination Male XLR with Pin1= -ve; Pin2 = +ve; Pin3= -ve and Source RCA with Centre = +ve; Body = -ve
Meanwhile ... I recall reading somewhere here that Destination Male XLR Pin1 should be left Blank.
-------------------------------------------------------------------------------------------------------------------
I also had a chat with Daniel of Oxford Audio Consultants and they confirmed that they've had no issues or any sort when they used the AQ Diamond RCA-RCA ... they haven't tried the mixed RCA-XLR so they couldn't say anything for that ...
Ideally ...
Scenario - 1 : Take 110 ohms AES/EBU cable, terminate Destination Male XLR with Pin1 = Gnd; Pin2 = +ve; Pin3 = -ve and Source RCA with Centre = +ve; Body = Gnd and -ve
OR
Scenario - 2 : Take 75 ohms S/pDIF cable, terminate Destination Male XLR with Pin1= -ve; Pin2 = +ve; Pin3= -ve and Source RCA with Centre = +ve; Body = -ve
Meanwhile ... I recall reading somewhere here that Destination Male XLR Pin1 should be left Blank.
-------------------------------------------------------------------------------------------------------------------
I also had a chat with Daniel of Oxford Audio Consultants and they confirmed that they've had no issues or any sort when they used the AQ Diamond RCA-RCA ... they haven't tried the mixed RCA-XLR so they couldn't say anything for that ...
