Developping a stereo system replacing spark + dialog

[ogs]

Thanks Ogs

You all say that Dialog is working well which simplify the work.

In 1 you say that I can connect Dialog to Phantoms through internet. I then probably misunderstood. I thought the Dialog was organizing a separated network with the phantoms from the house intranet (acting as a router of this specific network). If it is the case, I cannot connect Phantom and Dialog as only one RJ45 is available on Dialog. If it use the house network then it's a lot better than wifi. The only negative point is that the stream is going to dialog and then to the two phantoms multiplying the bandwidth usage on the network.

2 & 4 are questioning the volume management. This is the one I am having problem with. I would need, as you mention, either to modify the signal    or to understand how to communicate with phantom to control it"s internal hardware volume management (better)

3, does it means that I will have to adjust the volume of each room separately in this case ?

Best regards

1. yes you connect both the two Phantoms and Dialog to your ethernet switch. With wifi the Dialog will create a separate network with Phantoms unless you change the SSID to the one you use for your wifi network.

For 3 I believe you can still use the Phantom volume control to adjust 'both rooms', but it's here we need confirmation from a Phantom owner