24-Apr-2015, 05:30
(This post was last modified: 24-Apr-2015, 06:13 by completeluxury.)
so at this point i feel pretty stupid in all regards with my new devialet amp.
ive got air problems (another thread so no discussion of that here) but ive got another problem.
ive connected the dout1 on both units and in the configurator ive made my master and slave cards to operate that way.
i put the brown noise input on and i only get audio out of the master amp and not the slave! ive tried 2 different digital coax cables and neither worked.
does the slave configuration file have to be called something different than the master slave file? it says to name them the same but it doesnt really seem to be pulling the correct configuration from the file i put in.
my configuration file "name" is the stock custom when you enter the configurator but when i plug in the slave card it says "s1 config"
not sure if that is standard meaning slave 1 or whether its the name of the config file.
edit -
when i put both cards in, each amp will recognise whether its the slave or the master, it just seems like the link between them isnt functioning.
ive used both amps as masters at one point or another so i know that both speakers are connected correctly.
ive got air problems (another thread so no discussion of that here) but ive got another problem.
ive connected the dout1 on both units and in the configurator ive made my master and slave cards to operate that way.
i put the brown noise input on and i only get audio out of the master amp and not the slave! ive tried 2 different digital coax cables and neither worked.
does the slave configuration file have to be called something different than the master slave file? it says to name them the same but it doesnt really seem to be pulling the correct configuration from the file i put in.
my configuration file "name" is the stock custom when you enter the configurator but when i plug in the slave card it says "s1 config"
not sure if that is standard meaning slave 1 or whether its the name of the config file.
edit -
when i put both cards in, each amp will recognise whether its the slave or the master, it just seems like the link between them isnt functioning.
ive used both amps as masters at one point or another so i know that both speakers are connected correctly.
Amp - Devialet 400 Speakers - vivid audio B1 Speaker cable - audioquest oak Power conditioner - furman SPR 16IE Source - audio PC with paul pang audio usb card v3 and paul pang red dual usb cable running through jplay. usb card powered by teddy pardo power supply Source 2 - line in from integra AV receiver (TV)
