(08-May-2015, 23:07)amabrok Wrote:(08-May-2015, 23:05)kjj11 Wrote:(08-May-2015, 22:44)amabrok Wrote: Disconnect the master slave link and take out the SD card from ur slave unit a d reboot. This should boot up the slave unit in the factory default setup of D200. If this works then at least u know that the unit works and that the problem is with dual mono configuration
Sent from my iPhone using Tapatalk
All units indicates all as normal
But now I change my config and test standalone Devialet 200 configuration
And Ethernet port on it is silent! But if I back to 400 config - Ethernet works, but Phono didnt works
This is very strange
Maybe some power instability on home power line has dameged my Devialets?
Maybe. And I could be stating the obvious but make sure that all inputs in question are enabled and properly setup in the Configurator
Sent from my iPhone using Tapatalk
Yes
I'll try diffirent configs & what I found
- Optical, Spdif, Usb, Wi-Fi works correctly
- Ethernet works sometimes
- Line or Phono inputs didnt work - link status none
This is found in Devialet 400 configuration
On Devialet 200 now I'll see "wrong config" on any Config configuration
But on Factory Config Ethernet works fine
So, I'll wait Devialet support & answer to my Devialet dealer about repair