22-Aug-2015, 18:02
Got the Furutech Rhodium-plated/pure alpha copper blades IEC module installed this morning to replace the OEM Power Entry Module (sitting beside it in pic). No surprises here. Just open up the OEM cutout by 2mm at left side so flange doesn't partially cover LED at right in pic (cut-out height is perfect as-is) then drill & tap two M3X.5mm holes to accept the Titanium screws I cut short to fit this part. Then install. Total cake-walk project!
Statements in my posts are opinion only, not to be construed as fact. Any projects I engage in are at my own risk! Their outcome cannot be assured and may result in success, small/no change or catastrophic failure. I encourage no one rely on anything I say or do as gospel and to realize your mileage may vary!
