26-Jul-2014, 06:47
Hi
Well i sent in my two DP's for the upgrade and they are now enroute to Cape Town (currently somewhere in Germany)
In anticipation of my upgraded amps and the posting of the new firmware i logged on to the Configurator.
I previously connected my two D Premiers via RCA-AES/EBU cable (as was recommended by Devialet). But when using the Configurator i can seem to configure this type of connection between master and slave anymore using two 250's or 800.
Changing the units to DP's then i can change the input on the slave unit to either RCA or AES/EBU by clicking on the relevant input. But when the slave is a 250 it does not work
Has anyone else experienced this - is it a Configurator problem or does the 250 not allow the slave to use the AES/EBU input for connecting?
Worst case i will have to re-terminate the cable but want to find out prior to undertaking the surgery?
Well i sent in my two DP's for the upgrade and they are now enroute to Cape Town (currently somewhere in Germany)
In anticipation of my upgraded amps and the posting of the new firmware i logged on to the Configurator.
I previously connected my two D Premiers via RCA-AES/EBU cable (as was recommended by Devialet). But when using the Configurator i can seem to configure this type of connection between master and slave anymore using two 250's or 800.
Changing the units to DP's then i can change the input on the slave unit to either RCA or AES/EBU by clicking on the relevant input. But when the slave is a 250 it does not work
Has anyone else experienced this - is it a Configurator problem or does the 250 not allow the slave to use the AES/EBU input for connecting?
Worst case i will have to re-terminate the cable but want to find out prior to undertaking the surgery?
