In the interest of time savings and not changing things further in a very long line of changes I've decided to re-use the existing paper stickers affixed to the inductors via 100% silicone adhesive. The reasons are four-fold; 1, its the fastest way to get me back on track with reassembly. 2, it changes less than any other option which could be important upon reassembly if I have to go chasing issues that might occur once reassembled. 3, it will provide the longest-lasting repair due to silicone's high-temp characteristics and best insulation around any potential leakage areas. And 4, its a simple matter to gain total/complete access to these inductors from a fully assembled D200 minus its belly pan! Therefore I can easily re-do them seven-ways-to-Sunday if I perceive any benefit at any time post-reassembly with simple belly pan removal. Simply put, at this point in time this method is the most expedient, closest-to-OEM and least invasive/risky of all other options available to me.
Statements in my posts are opinion only, not to be construed as fact. Any projects I engage in are at my own risk! Their outcome cannot be assured and may result in success, small/no change or catastrophic failure. I encourage no one rely on anything I say or do as gospel and to realize your mileage may vary!