Posts: 433
Threads: 44
Joined: Apr 2015
Reputation:
6
Close but no cigar today. D200 is totally reassembled save for the PEM-to-IEC conversion wiring connection to the Devialet power board. All I have left to do is desolder and remove the two female quick-connect spade receivers under the power board and located just above the words "FUSE" & "F2" in pic. Then I'll strip and solder the crystal Cables high-current leads to the board at those spots. Once I do that I just need to place the copper washer under the IEC/chassis ground screw and close it up. Sounds like very little but probably 2-3 hours work as I need to closely inspect & go over everything with a fine-tooth comb before replacing the belly pan.
But now its time to enjoy a grinder of my local favorite micro-brew and nestle into some Sunday Night NFL. Man's gotta have his priorities straight!
Statements in my posts are opinion only, not to be construed as fact. Any projects I engage in are at my own risk! Their outcome cannot be assured and may result in success, small/no change or catastrophic failure. I encourage no one rely on anything I say or do as gospel and to realize your mileage may vary!
