12-Aug-2014, 15:23
Hi,
I just checked my meters and they did not even reach 40 dB.
I had the impression that the output level in the Devialet should be adjusted so that you are a bit over your cartridge output. In my case Benz say 365 uV output on my LPS and my setting is 400 uV. Did I misunderstand the whole setting process? As I see it, due to the digitalization a level should be set slightly over (to avoid oversteer) the cartridge level so that signal out will be maximized ie making best use of all the dig bits, or am i wrong there too?
Sampling setting is 96 kHz as recommended by Dev.
To get my levels up what to do, load or output level or both?
/Mike
I just checked my meters and they did not even reach 40 dB.
I had the impression that the output level in the Devialet should be adjusted so that you are a bit over your cartridge output. In my case Benz say 365 uV output on my LPS and my setting is 400 uV. Did I misunderstand the whole setting process? As I see it, due to the digitalization a level should be set slightly over (to avoid oversteer) the cartridge level so that signal out will be maximized ie making best use of all the dig bits, or am i wrong there too?
Sampling setting is 96 kHz as recommended by Dev.
To get my levels up what to do, load or output level or both?
/Mike
Ex D400 Now Aavik U-300/Feickert Woodpecker2-Kuzma 4P-Kondo silver-Benz LPS-Teddy Pardo PSU/Naim Unitiserve-Teddy Pardo PSU/SF Guarneri Homage/Whole system decoupled by Ansuz DTC/Cables from Ansuz, DYI and other commercial/Dedicated mains and spur-Lampizator SILK