26-Jan-2016, 19:09
(26-Jan-2016, 18:16)ciptip Wrote: Hello there,
Help needed!
I have a strange clipping problem on my 120 and I suppose is due to the phono config; it's strange cause pulled out the phono cables and it was still clipping (those about 10 clipping that you can loudly hear on the speakers each 5 seconds). I configured the phono input for a Rega Apheta at 500mvolt, mc, high; there are not so many config options as in the bigger 200 or 250s. As far as I understood it is suggested that I should put a bigger value than the one stated by Rega.
Hi,
Can you try to explain a little better what it is you experience?
You say that you pull out the phono cable (I assume you mean out of the Devialet, leaving the inputs on the Devialet-end empty?) and you then hear a constant sound (please describe: white noise or hum or ..?) or is it a 'blip' every 5 seconds?
If it is a blip it could be due to having wifi on the Devialet enabled, it's described in the manual. If you pulled out the cable on the turntable end, leaving open-ended cables in the Devialet input, it could be the cable picking up noise or the cable might be defective. Did you connect the separate ground wire correctly from the turntable to the Devialet?
