17-Apr-2016, 07:10
Just to add a bit of clarity here.
If my units are powered down completely, that is say turned off at the mains, then I will get 'S1 config' on initial start up.
However, if the amps are in the normal stand by mode (turned off, say, with a short press on the remote on / off button), then on start up the companion will show 'Companion Devialet 800', no mention of 'S1' at all. (I believe 400 behaviour is the same)
I will also initially get 'S1 config' during the process of loading a revised configuration card.
I am running my amps without the trigger cable and using the AES/EBU input to the companion for the master / companion link cable.
If my units are powered down completely, that is say turned off at the mains, then I will get 'S1 config' on initial start up.
However, if the amps are in the normal stand by mode (turned off, say, with a short press on the remote on / off button), then on start up the companion will show 'Companion Devialet 800', no mention of 'S1' at all. (I believe 400 behaviour is the same)
I will also initially get 'S1 config' during the process of loading a revised configuration card.
I am running my amps without the trigger cable and using the AES/EBU input to the companion for the master / companion link cable.
1000 Pro - KEF Blade - iFi Zen Stream - Mutec REF10 - MC3+USB - Pro-Ject Signature 12
