Under General Settings in the Configurator, on the Startup page, make sure that Sub/Preout is ticked. Next, click the input next but one to the AES/EBU on the companion to activate it, select the settings arrow and tick the Pre-amplified Output (Stereo) circle. Leave all of the options as they are and close the box. You will see that the two inputs are now labelled "Preout". Save the configs to the relevant cards, put them back in the amps, turn them on and wait for the amps to start up and load the new configurations. Connect a pair of cables to these terminals and hook them up to your power amp(s). This is assuming that you have your companion connected by its AES/EBU terminal.
If you connect your amps RCA to RCA, choose any two inputs that you're not using and configure them to be mono outputs. You can change which one you want to be left/right channel.
Hope this helps.
If you connect your amps RCA to RCA, choose any two inputs that you're not using and configure them to be mono outputs. You can change which one you want to be left/right channel.
Hope this helps.
Project Eperience X Pack with Ortofon Rondo Red MC, Oppo BDP 105D, 2 x Sonos Connect, QNAP HS251+ NAS with 2 X 6TB Western Digital Red, Mac 5K 32GB running Lifetime Roon, iPad Pro 12.9" for remote control. Etalon Ethernet Isolator, Devialet 440 Pro CI, Sonus faber Olympica ll with Isoacoustics Gaia ll feet, Auralic Taurus Mkll headphone amp., Denon AH-D5000, Sennheiser HD600 and HD800 with Cardas cable, Van Den Hul The First Ultimate and Crystal interconnects, Furutech power cables, GSP Audio Spatia speaker cable.
South Coast England
