Just to clarify - the Blade 2 have 4 binding posts each. A set for the mid/treble and a set for the bass. There is a jumper built into the speaker that can be engaged to run one set of binding posts, or the jumper can be disengaged to wire the mid/treble on one set of speaker cables and the bass on a separate set of cables. What I want to do is use all four sets of binding posts on the speaker.
The question I have is when running a dual mono block configuration, can I use one set of binding posts on my master to go to the treble section of the speaker and the other set to go to the bass? In other words, can I use all four posts on my right monoblock, and all four posts on the left mono block to do this? There would be four separate runs of speaker cable - two to the left speaker and two to the right speaker.
The question I have is when running a dual mono block configuration, can I use one set of binding posts on my master to go to the treble section of the speaker and the other set to go to the bass? In other words, can I use all four posts on my right monoblock, and all four posts on the left mono block to do this? There would be four separate runs of speaker cable - two to the left speaker and two to the right speaker.
