15-Sep-2017, 14:17
When you load new firmware, the Devialet deletes one file from the SD card so it knows that this task is complete and thus the amp will not re-load the firmware when re-stared in the future. You can disable this by switching the SD card to read only, in which case the Devialet will see that the subject files is not deleted, and hence think it is new firmware and load it each time the amp is fully powered down and then up again. You can run a Devialet without firmware on the SD card, you just need the configuration. Certainly the Devialet cannot re-load firmware if it is not on the SD card.
So I can see a scenario where a fully powered down Devialet will reboot and load firmware whenever started if the SD card is switched to read only.
Could this be influenced by the power cord? Impossible I would say. Maybe a coincidence? Have you changed the configurations / SD cards at the same time as switching cords?
So I can see a scenario where a fully powered down Devialet will reboot and load firmware whenever started if the SD card is switched to read only.
Could this be influenced by the power cord? Impossible I would say. Maybe a coincidence? Have you changed the configurations / SD cards at the same time as switching cords?
1000 Pro - KEF Blade - iFi Zen Stream - Mutec REF10 - MC3+USB - Pro-Ject Signature 12
