25-Oct-2017, 22:08
I'm trying to understand this for practical application in my system. I have two active subs (ELAC SUB-2090) where I set the crossover frequency at 80Hz. I believe it's second order but the manufacturer doesn't specify. The Devialet is set for high-pass at 80Hz / second order at the speaker level.
Given the data above, would I be on safer grounds just setting both the low pass (at pre-outs) and the high-pass (at speaker level) on the Devialet and use the subs 'full range'??
I would appreciate any help on this as I have a feeling that I haven't fully managed to integrate the subwoofers.
Zoltan
Given the data above, would I be on safer grounds just setting both the low pass (at pre-outs) and the high-pass (at speaker level) on the Devialet and use the subs 'full range'??
I would appreciate any help on this as I have a feeling that I haven't fully managed to integrate the subwoofers.
Zoltan
Win10/HQPlayer / Roon - Uptone Audio Etherregen switch / SOtM-SMS-200 ultra with clock input - Mutec REF 10 clock for the switch and the streamer - Denafrips GAIA DCC - Devialet D800 - YG Acoustics Carmel - Dual Elac SUB-2090
power supplies: Uptone JS-2, SOtM SPS-500
