15-Oct-2018, 15:36
You can of course connect a sub directly to the speaker terminals using a 10k and a 2k resistor. The problem with this is that the main speaker is still receiving the whole frequency band.
With the pre-out, you can configure the Devilalet to send signals, say from 150Hz to the main speakers and let the sub do the work under 150Hz
Some subs have a built-in passive crossover, allowing you to connect main speakers which will receive a filtered signal. The T5 is not one of those however
With the pre-out, you can configure the Devilalet to send signals, say from 150Hz to the main speakers and let the sub do the work under 150Hz
Some subs have a built-in passive crossover, allowing you to connect main speakers which will receive a filtered signal. The T5 is not one of those however
Cape Town - South Africa, the home of good wine
Mercury Pi2 & Gentoo, Expert 440PRO CI. 4Tb SSD. ML Electromotion, REL sub. 2 x Dachshunds
Mercury Pi2 & Gentoo, Expert 440PRO CI. 4Tb SSD. ML Electromotion, REL sub. 2 x Dachshunds