220 Pro sub woofer SAM on or off?

[disarmamant]

I would not filter the main speaker as this negatively affects the whole music signal. The 30.1 goes only down to 50Hz. Set SAM to 0% and the lowpass for the sub to something between 40 and 60 Hz.
SAM will not effect the sub as Jean-Marie already said. Try if SAM set to 0% is doing good things at all, otherwise leave it off.

Thanks for the replies. I have set the M30.1’s back to full range in the configuration. I still have the sub output at full range as the plate amplifier has an annoying standby function after no signal for one minute.

If there is no bass content when the sub goes into standby it makes an annoying farting noise!


Sent from my iPad using Tapatalk