(25-Dec-2017, 14:46)disarmamant Wrote:My missus does that when she goes into standby mode in bed. I find that a swift kick up the Khyber usually solves the problem.(25-Dec-2017, 12:18)Vivialet Wrote: I would not filter the main speaker as this negatively affects the whole music signal. The 30.1 goes only down to 50Hz. Set SAM to 0% and the lowpass for the sub to something between 40 and 60 Hz.
SAM will not effect the sub as Jean-Marie already said. Try if SAM set to 0% is doing good things at all, otherwise leave it off.
Thanks for the replies. I have set the M30.1’s back to full range in the configuration. I still have the sub output at full range as the plate amplifier has an annoying standby function after no signal for one minute.
If there is no bass content when the sub goes into standby it makes an annoying farting noise!
Sent from my iPad using Tapatalk
Sorry for the bad joke. Too much Christmas booze!
Project Eperience X Pack with Ortofon Rondo Red MC, Oppo BDP 105D, 2 x Sonos Connect, QNAP HS251+ NAS with 2 X 6TB Western Digital Red, Mac 5K 32GB running Lifetime Roon, iPad Pro 12.9" for remote control. Etalon Ethernet Isolator, Devialet 440 Pro CI, Sonus faber Olympica ll with Isoacoustics Gaia ll feet, Auralic Taurus Mkll headphone amp., Denon AH-D5000, Sennheiser HD600 and HD800 with Cardas cable, Van Den Hul The First Ultimate and Crystal interconnects, Furutech power cables, GSP Audio Spatia speaker cable.
South Coast England
