Firmware 12.2.10

[philoouu]

another problem I have is with AIR. upnp is working fine, but SQ can't compete with my Mutecs. But AIR is another thing. It was always working fine, even the white noise what not a big issue for me. But now the AIR driver always shows 0.0db for Wifi even if it is working. Ethernet is working, but if I switch to another source and then back I can't get it working again. Similar for Wifi, even worse. Only a complete powerdown of the amps is solving it, but it is only working for a short time. Totally unstable.
For both Wifi and ethernet I'm using DHCP.
Not really a problem as I tend to stay with Mutec. And the AES input is sounding clearly better with the CI board.

Hello Vivialet
I am still with the previous Beta version. (lucky me)
Although I only use USB I need either ethernet or Wifi working for the Iphone remote control.
Those are my findings so far (DHCP on, no reservation at the router level either):
- if I remove the lan cable, reboot, wireless will be OK and will not disconnect.
- if I keep the lan cable, rebooot, only Ethernet will work but will disconnect after a few hours/days.
- now I have removed the wireless in the configuration and I am testing if Ethernet will stay connected.

Obviously there are issues as there is no reason both Ethernet/Wireless cannot work at the same time!
The interaction between both is not clear: in Ethernet mode you do not see the same name than in Wireless mode for your device...
I have been upgraded to CI a month ago and I have not still be able to use my Devialet properly.

philoouu