Hello,
Just managed to have the Dev app to communicate with the unit. All I did was config to enable the ethernet i/o on the master. Everything works ok but when trying to use my analogue input on the companion (my only input with exception from the master input) it just acknowledge it for half of a second and then just shuts down the companion??? All other inputs on the master have no problem. When I then chose another input (on the master) the companion starts again!
Any one with a clue to what is going on?
/Mike
Just managed to have the Dev app to communicate with the unit. All I did was config to enable the ethernet i/o on the master. Everything works ok but when trying to use my analogue input on the companion (my only input with exception from the master input) it just acknowledge it for half of a second and then just shuts down the companion??? All other inputs on the master have no problem. When I then chose another input (on the master) the companion starts again!
Any one with a clue to what is going on?
/Mike
Ex D400 Now Aavik U-300/Feickert Woodpecker2-Kuzma 4P-Kondo silver-Benz LPS-Teddy Pardo PSU/Naim Unitiserve-Teddy Pardo PSU/SF Guarneri Homage/Whole system decoupled by Ansuz DTC/Cables from Ansuz, DYI and other commercial/Dedicated mains and spur-Lampizator SILK
