"hacking" SAM to do convolution

[RayMo]

Hi,
I really wish to have a room correction too. I have been imaging, what would be the quickest implementation way for Devialet, and good enough solution for my needs for now, until a room correction is available(?) in Devialet. I think, the Tone Control can be as it is, because of the ability to adjust tone from remote control for differently mixed audio.
I would add one tab into the configurator screen besides Tone Control tab.
There I would like to see a parametric EQ screen, where I can add a rows of EQ settings / channel, (max 32 / channel?),
for example,
Left:
30Hz, +3db, band width value1
45Hz, +2db, band width value2
100Hz, -4db, band width value3
...
Right:
30Hz, +2db, band width value4
52Hz, +4db, band width value5
110Hz, -2db, band width value6
...
Yes, lot of work to write settings into SD, load it in, and test/measure, and configure again. But once done, it is done.

What do you think, pros/cons?

Best Regards, RayMo