Phantom Remote not working

[Johnnydev]

Bluetooth is not needed.
Just do a complete factory reset with dialog and phantoms and everything functions as before.
I have 3x remotes

Right, powercycling the two Phantoms and after a minute reconnecting the Dialog did it. My remote is working again.

Thanks to all for their helpful comments.

I have Bluetooth disabled, but remote support enabled.

Additionally, their English is a bit confusing because when remote support is on it says "enable" (expressing a command as in Do-This-Now), but in fact it is already enabled....  "Enabled" would be the correct grammatical form expressing a state.

This was a small reset, but a Total factory reset do sometimes miracles. Sometimes also for using spark and the app etc. and i also have the assumption for de SQ