28-May-2019, 03:12
Hi, folks. I have a D-Premier and I'm confused about the sub output.
In General Settings, under Startup Mode, I have both "Sub/Preout" and "Subsonic filter" toggled ON.
I have Input 1 set to "Phono Input," and under Special Modes, "Sub/Preout" is toggled ON.
I have the digital RCA jacks configured as "Preamplified Output (Stereo)." These feed a subwoofer in stereo with a Low Pass filter set at 50Hz.
But the D-Premier always boots up with a 2.0 bass configuration, instead of 2.1, as I intended. (If I switch to 2.1, the sub works properly, so I know that's not the problem.)
What am I doing wrong? Thanks!
In General Settings, under Startup Mode, I have both "Sub/Preout" and "Subsonic filter" toggled ON.
I have Input 1 set to "Phono Input," and under Special Modes, "Sub/Preout" is toggled ON.
I have the digital RCA jacks configured as "Preamplified Output (Stereo)." These feed a subwoofer in stereo with a Low Pass filter set at 50Hz.
But the D-Premier always boots up with a 2.0 bass configuration, instead of 2.1, as I intended. (If I switch to 2.1, the sub works properly, so I know that's not the problem.)
What am I doing wrong? Thanks!
