You can turn them into low power standby mode, by pressing the rear button for some seconds, until it makes the standby signal.
In this Mode it consumes <1 watt and you don’t loose your configuration. One short press again brings them to life again.
I opened a ticket to request an enhancement for the web UI to switch the phantoms into this low power standby mode, but the answers so far were unacceptably denying.
When you disconnect them from power, the config gets lost under DOS 2. I guess before, this config was held on the Dialog box, even when disconnecting from power.
Greetings,
Chris
In this Mode it consumes <1 watt and you don’t loose your configuration. One short press again brings them to life again.
I opened a ticket to request an enhancement for the web UI to switch the phantoms into this low power standby mode, but the answers so far were unacceptably denying.
When you disconnect them from power, the config gets lost under DOS 2. I guess before, this config was held on the Dialog box, even when disconnecting from power.
Greetings,
Chris
