30-Mar-2021, 15:25
Little update. I've just realised why this remote is not working properly and fluctuating about a setpoint, the encoder markings in the first image have to be within a certain distance from the sensors, and upon disassembly the clips holding the PCB in place snapped off. This causes the PCB to pushed about 1-2 mm too far from the sensors. If I hold the PCB in the right place, the remote works as expected. I attach a closeup of the part I tore off. The remote seems to work ok without it, I assume it did some filtering. Does anyone here happen to recognise the component? I've just ordered an LCR meter as I've misplaced my old one, and will try and measure the inductance from what's left of the part!
