Problem with ROON

[Jean-Marie]

I'm not certain that the failure to show SAM at 0% is a Roon issue, it may be a Devialet issue.

What Roon shows in the signal path is a combination of what Roon is doing and what the Roon Ready end point reports that it is doing. If the Devialet does not tell Roon that SAM is active at 0% then Roon will not show SAM in the signal path info.

Perhaps Roon made a decision not to show things like tone controls and SAM in the signal path info if the setting was zero, or perhaps Devialet don't report zero settings to Roon so Roon can not display that info. We simply don't know whose problem it is. Since the issue has been posted on the Roon forum I suspect we'll hear something from Roon much sooner than we could expect to hear something from Devialet who don't seem to like communicating publicly with their customers.

@David A, you are absolutely right, we have no way to tell who is the culprit between what Devialet reports and what Roon does with the information. 

Jean-Marie