25-Feb-2023, 20:24
Just found after the 1.20 update the WSA hosted app was unable to connect/find anything.
what i did to get it working again.
1) update, this is a manual process...Get the latest app APK 1.20 and install it using ADB again.
Symptom: after install, running the app still did not see any of the previously configured devices.
APP complained about no LOCATION services NO BT.
Symptom: appears like BT was not enabled, location services etc.
enable BT and Location services. still no joy hung up on the BT enablement. *(in the devialet app, says BT is not enabled)
2) Goto the WSA Settings. Enable Advanced Networking setting.
Start the app, it found the previous Devialet devices that were setup
Afterwards, turn off BT and Location services. (at your discretion / preference) seems to be ok.
but turning off the advanced network settings caused the app to fail to find any devices.
not sure if that's DUE a change in WSA (its been updated over the past few months) the Devialet APP or a combination of both.
other than the Network settings change 1.20 is working under WSA ok here.
what i did to get it working again.
1) update, this is a manual process...Get the latest app APK 1.20 and install it using ADB again.
Symptom: after install, running the app still did not see any of the previously configured devices.
APP complained about no LOCATION services NO BT.
Symptom: appears like BT was not enabled, location services etc.
enable BT and Location services. still no joy hung up on the BT enablement. *(in the devialet app, says BT is not enabled)
2) Goto the WSA Settings. Enable Advanced Networking setting.
Start the app, it found the previous Devialet devices that were setup
Afterwards, turn off BT and Location services. (at your discretion / preference) seems to be ok.
but turning off the advanced network settings caused the app to fail to find any devices.
not sure if that's DUE a change in WSA (its been updated over the past few months) the Devialet APP or a combination of both.
other than the Network settings change 1.20 is working under WSA ok here.
