04-Mar-2015, 09:13
I would make an acrylic box section "channel" for the wires , and make it decorative , a lot of places with laser engravers etc can do one for you and still do some engraving on the surface you see..
Otherwise you could use an aluminium extrusion thats used for boxes for electronic gear , most electronic supply houses have a selection of these
Otherwise you could use an aluminium extrusion thats used for boxes for electronic gear , most electronic supply houses have a selection of these
Roon/tidal > Squeezebox touch > Trinnov St2 or DIRAC (minidsp ddrc-22d) > Dual mono D premiers > Vivid Audio Giya G1 Spirits ...fully treated dedicated 6x8m room