Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
are you using SAM with your D400?
#6
(12-Jun-2015, 20:33)jfp Wrote: Yes I use SAM on D400 with my Apertura Onira. When they were samed I noticed a clear step up ! and I can tell you that recently by mistake (my kid or me) Sam had been switched off and I felt the music was not as good as usually. I checked and put SAM On again.
The only question I have is about the 100%. I am. But I did not try a 50% sam for instance.

The % represents how much low end extension SAM gives you.  0% mean no bass extension just phase alignment, your speakers are theoretically producing the frequency response on the manufacturer's spec sheet.  100% is maximum extension your speakers are capable of, the number Devialet advertises with each SAM profile.

Rooms setup might now allow you to go crazy with % without getting major room interaction.  Larger speaker might need little to no extension.  Each situation is different.
Roon->HQPlayer->McIntosh C47->McIntosh MC301s>Transparent Super->Wilson Audio Sabrinas w/ Shunyata Denali, Rega RP8, Rega Apheta 2


Reply


Messages In This Thread
are you using SAM with your D400? - by miro - 28-Apr-2015, 05:26
RE: are you using SAM with your D400? - by jfp - 12-Jun-2015, 20:33
RE: are you using SAM with your D400? - by Dr Tone - 12-Jun-2015, 21:16
RE: are you using SAM with your D400? - by jfp - 13-Jun-2015, 09:58

Forum Jump:


Users browsing this thread: 1 Guest(s)