I have recently purchased a D250 slave. It works ok but I have a problem with trying to use one digital input in the slave. The link cable is connected, I have double checked that it is to the correct sockets, (lower socket master, upper on slave) The link cable is connected via the two digital SPDIF's. Turn on the master, the slave turns on, scroll through the inputs, they run in sync. However, if you select the digital input from the slave (digital 2), the slave simply turns off. Chaining input is selected, share sources from slave is selected. All other inputs work fine, it is just when I select the digital input from the slave, the slave shuts down. The link and digital cable are as supplied by Devialet.
By the way, tried a second link cable as a double check. Same result. However, it makes no difference if I disconnect the link cable, I'm beginning to think something faulty here....
By the way, tried a second link cable as a double check. Same result. However, it makes no difference if I disconnect the link cable, I'm beginning to think something faulty here....
