14-Aug-2014, 13:41
(14-Aug-2014, 00:59)Mikeeo Wrote: Tried to see if I could make my bars go higher or lower tonight. Tested one output level only 10 uV over (ie 570 uV) the Benz spec output and the a doubled one at 1100 uV.
Here comes the funny bit; No change on the meters behavior, still just slightly under -40 dB for both settings, however at the lower setting I def. had a louder sound than the higher output setting. What does this mean? The bars/meters have no practical use in 'optimizing' signal from phono. So what are they actually showing?
/Mike
I also tried the 192 kHz setting but I couldn't hear any difference or at least I was ambivalent about it.
/Mike
Changing the gain by only 3dB may well not be noticed on the somewhat small display.
There is no sensible reason why the 192 setting would be different. All the extra data only contains any information in the 48kHz to 96 kHz octave...
Devialet Original d'Atelier 44 Core, Job Pre/225, Goldmund PH2, Goldmund Reference/T3f /Ortofon A90, Goldmund Mimesis 36+ & Chord Blu, iMac/Air, Lynx Theta, Tune Audio Anima, Goldmund Epilog 1&2, REL Studio. Dialog, Silver Phantoms, Branch stands, copper cables (mainly).
Oxfordshire
