17-Aug-2014, 10:46
(16-Aug-2014, 10:02)Mohmm Wrote:(15-Aug-2014, 08:27)Vivialet Wrote: Hi Mohmm,
there is currently only one way to get a digital output: you have to disable the inputs on the slave. Then select the chaining input of the slave and select a digital output. This will automatically use the AES/EBU input for chaining.
This is of course not ideal if you really need additional connections on the slave...
OK, thanks, I discovered this in the configurator. Losing additional inputs is not too bad for my setup.
However, an RCA to XLR cable brings up the impedance question: 75 or 110 ohm?
I remember this issue has been discussed in this forum but without a real solution.
About the 75 vs 110 ohm I remember Thierry (@ Devialet) telling me that a 75 ohm cable should be used and their proprietary solution at the AES/EBU side will handle the impedance issue.
/Mike
Ex D400 Now Aavik U-300/Feickert Woodpecker2-Kuzma 4P-Kondo silver-Benz LPS-Teddy Pardo PSU/Naim Unitiserve-Teddy Pardo PSU/SF Guarneri Homage/Whole system decoupled by Ansuz DTC/Cables from Ansuz, DYI and other commercial/Dedicated mains and spur-Lampizator SILK