26-Feb-2016, 21:43
As Antoine wrote the Dev is by no means bright, but it's VERY transparent and therefor emphazises on every resonances that you throw at it. A brightness is nothing less than frequency-resonances delivering an out of (time) phase signal at this frequency. The cause of these out of phase signals can be multi. Best to begin is the powerLine/Cables.The right position of the powerphase (hotwire) of the IEC, if you look from behind your Dev, is the pin on the right side. Sure you got this right already. You didn't write anything belongs to power. So that is just my two thoughts on brightness.
Next comes the source and the cable connected from source to Dev and all the points Antoine mentioned.
Problem of the Dev is it's crystal clearness and if not accompanied the right way emphazises on every fault in the chain. Just expect the Dev being your magnifying glass on it. For us not being at your sight it's trial and error.
gui
Next comes the source and the cable connected from source to Dev and all the points Antoine mentioned.
Problem of the Dev is it's crystal clearness and if not accompanied the right way emphazises on every fault in the chain. Just expect the Dev being your magnifying glass on it. For us not being at your sight it's trial and error.
gui
"Oh, you can buy the other. But then it is a cost intensive learning process"
berlin
