D400 / companion boots on S1 config...?

[Christophe]

I recently bought a D200 as a companion of my former D200 and I am facing what I think is an issue.
On Devialet on-line configurator, I configured both the master and the companion as a D400 set up, downloaded and installed the respective configs of the master and the companion. However, when turning on the 2 D200 (chained via RCA to RCA), the companion boots on a config named "S1 config" which makes me think that the companion does not boot on the appropriate config.
Devialet support team confirmed me that this is the symptom of a mismatching between the 2 amps and it may be caused by the 2 amps not running the same firmware version. Given the companion was shipped with 9.0.2 while the master was in 9.0.1, I downgraded the companion to the 9.0.1 version, strictly identical to the master's one. Despite this, the companion keeps booting on the "S1 config"...
Hence need help and my questions. Have you also experienced the same thing? And to those of you owning a D400, could you please tell me what you observe on the companion display when booting?
Thanks!

I just upgraded to a D400 as well (love the sound!) - the companion unit I believe says s1 config when it boots using my custom config though I use the trigger cable - my new d200 companion unit was running 8.1.3 when it arrived and I upgraded to 9.0.1 before I slaved the unit to my original master.  After the slave boots up it will say "companion" above the D400 logo.   Does your new companion not communicate with the master?

Same behavior on my side. When booting, the companion says "S1 config", then presents "companion" above D400. They both seem to communicate since both left and right channels are playing and SAM as well. However, I have a doubt about which configuration the companion is running with, because the Devialet team told me that S1 config is the one the companion defaults on when not well paired with the master.
Very confusing...