08-Aug-2016, 04:37
(08-Aug-2016, 04:16)Duomike Wrote:(22-Jul-2016, 18:02)GuillaumeB Wrote: FIRMWARE V10.0.2
- Support of the new Expert Pro line
- New graphical chart
- Original d’Atelier reaches 1000 Watts of power
Guillaume
Tried upgrading to the new firmware. Got following error message:
SW. FF. FF
H.W 5.0.0
SD card error B 351
DSPD 0210.HEX
Does anyone got a clue what went wrong? Acc. to instruction from dev help site the sd card must be empty before copying the 17 files. Initially i left the configuration on the disk because a friend did so without problems.
Deleted the conf. file but problem still unchanged.
If I delete the 17 files will my dev automatically go back to the previous FW?
This is what I do every time I make any change (firmware or configuration)
I delete the files from my SD card. Then take my SD card out and re-insert it. I then check whether it is empty or not. Only once I've confirmed it's empty I copy the new files over.
It might just take a minute longer and it shouldn't need to be done but in the end I know it always works so it saves time re-doing things.
Good luck!
Pim
Lifetime Roon, Mac mini, int. SSD, ext. HDD, tv as monitor, key board and track pad on bean bag as remote,Devialet 200, Od'A #097, Blue jeans speaker cable,
Dynaudio C1 MkII.
Jim Smith's GBS.
Northern NSW Australia.
Dynaudio C1 MkII.
Jim Smith's GBS.
Northern NSW Australia.
