Firmware 10.0.2 is now available for download

[neXus 6]

FIRMWARE V10.0.2

- Support of the new Expert Pro line 
- New graphical chart
- Original d’Atelier reaches 1000 Watts of power


Guillaume

Tried upgrading to the new firmware. Got following error message:

SW. FF. FF
H.W 5.0.0
SD card error B 351
DSPD 0210.HEX

Does anyone got a clue what went wrong? Acc. to instruction from dev help site the sd card must be empty before copying the 17 files. Initially i left the configuration on the disk because a friend did so without problems. 
Deleted the conf. file but problem still unchanged.

If I delete the 17 files will my dev automatically go back to the previous FW?

This is what I do every time I make any change (firmware or configuration)
I delete the files from my SD card. Then take my SD card out and re-insert it. I then check whether it is empty or not. Only once I've confirmed it's empty I copy the new files over.

It might just take a minute longer and it shouldn't need to be done but in the end I know it always works so it saves time re-doing things.

Good luck!

Pim

Ditto-ish. I have 2 sets of cards and always use a clean pair for any change whilst retaining the previous pair in case or problems. As a further precaution, I keep a back up of every config I've used and every firmware update on my PC in case Paris decides to delete any archives or reduce config options.