(15-Nov-2016, 18:30)ogs Wrote:(15-Nov-2016, 17:57)yabaVR Wrote:Sorry for hijacking your thread JohnnySix.
@ ogsNo, don't use all 7-pins. I used 2 and it sounds just beautyful. Best would be to drill a hole into the mainboard and solder directly onto the board. Or even better to solder on to the next electrical part in the signal path. But then you have to rip of the mainbord. That's for the next time for me.
The Cardas in the link seem to be for loudspeakers since they are very long. They won't fit. Perhaps there is a shorter version? Other than that I consider Furutech's new 'low mass' series.
gui
I agree; apologies to JohnnySix!
This is very interesting though, should be moved into it's own thread in 'Tweaker's Corner'. Mods?
The Cardas binding posts exists in 'long' and 'short' versions. The link provided was to the insulators for mounting in metal plates. Requires half-inch holes. Look here for the complete range: http://www.cardas.com/parts_binding_posts.php
I don't see any problems for the short version. They would fit for sure. Might be interesting to compare these Cardas to Furutech's FT-865 R (Massiv vs. Low Mass)
gui
why do we have to do this DEVIALET 
"Oh, you can buy the other. But then it is a cost intensive learning process"
berlin
