12-Dec-2016, 13:16
(12-Dec-2016, 11:46)warpeon Wrote: YabaVR, I think what u did is very interesting and make sense - it is like the amp's out put is bottlenecked by the riserboard before releasing to the speaker posts. would you mind showing a photo of the riser board? I am thinking may b a more warranty friendly mod is to solder the speaker post to a pin connector cable? And possibly cryo that direct connection mod piece?
Yes that was my mod before. I soldered a cable from binding post to the pins...but I have to say that soldering the cables directly to the D-Amp Connector Contacts was a big improvement over the other soldered to the pins. I was surprised myself. Didn't expect that much of a difference. The pins are of no good within the signal chain.
But see the riserboards, anyway it's better to get rid of it first
gui
"Oh, you can buy the other. But then it is a cost intensive learning process"
berlin