12-Aug-2017, 22:46
(This post was last modified: 12-Aug-2017, 22:49 by Hifi_swlon.)
Ok, medium story very short as no time tonight.... but they're on. Was easier than anticipated (well one set anyway) and did it in situ with quite a lean over. Fairly uneventful bar a sliced finger - the threads on one were really sharp!! - and a few locking rings that refused to fit.
No time to listen or finish levelling / orienting logos but that's for another day. I can see orienting will be tricky as there's no detent, and the logo's quite long and minimalist so getting them all facing forwards/backwards may be the hardest part yet.
They're higher than I'd like but not as bad as I thought.
Also not quite sure how you level them as by their nature they are quite self-levelling. Does it matter if all loads aren't even? I guess they are all even, but maybe not under the same tension? Might be a question for using-acoustics.
No time to listen or finish levelling / orienting logos but that's for another day. I can see orienting will be tricky as there's no detent, and the logo's quite long and minimalist so getting them all facing forwards/backwards may be the hardest part yet.
They're higher than I'd like but not as bad as I thought.
Also not quite sure how you level them as by their nature they are quite self-levelling. Does it matter if all loads aren't even? I guess they are all even, but maybe not under the same tension? Might be a question for using-acoustics.
>>> 1st Place Award: Devialet, last decades most disappointing technology purchase. <<<