Phantom elevate set up problem

[tsmithpam]

I had issues when going optical to dialog and then regardless of wifi, plc or ethernet to the phantoms (one of the phantoms would cut out for a sec every few minutes). Now I go optical to one phantom and run wifi. Dialog is connected to router via cat6 ethernet.

Hi
I have the Dialog connected direct to route via the ethernet cable it came with. I am currently feeding optical into the dialog. I will try tonight the optical into just one phantom. Do I need to change anything in Spark to ensure it plays to both now it is not going into dialog. 

Whilst I will definitely try this I suspect i will still have problems as it happens also on UPnP as well as optical. There could be something in the point raised earlier about which circuit the dialog and two phantoms connect to. 

I'll update later on how I get on......Hopeful and grateful for your ideas...