FW 2.11.2 out

[mingfang]

Hi,

just made measurements. 57 ms is the lowest latency i can get.
So it was not low latency optical mode....
sad...

my mistake. When i press 5X the button : no direct mode / but factory reset........
i contact Devialet Support. Disapointed

Hi,

In fact, on my reactor if i press X5 the rear button quickly, i'm in Store mode (not direct mode), and only optical works (direct) with manual volume, it's direct optical mode but measured at..............measured at 190 ms..... direct mode at 190ms.
And after few minutes, this false 190ms direct mode is desactivated.

so, i believe it's the same case for Phantom Premier.

So the X5 rear button, it's not the good process, to have "low latency optical mode..."  it's a buggy Direct optical store mode measured at 190 ms with my RTA mic, in REW and Smaart...

i've asked Devialet to the right "how to" for low latency mode  (i've opened a request number)

Hi.  So in my environment, I'm running all of my reactors in "Custom Install Mode".  The reactor's don't have an "Optical Direct Mode" option.  Simply pressing the button rear button doesn't activate "Custom Install Mode".  You have to go through a series of steps to get the Reactor into it.  

The reactors have a hard limit of 190ms latency when in "Custom Install Mode" and I've confirmed that.  Per my conversations with Devialet, the Reactors will always have much higher latency than the Premieres.  This is due to the architectural changes they made when designing the Reactors.

Hope this helps

Can you please share the "series of steps" to get the Reactor into Optical Direct Mode?