06-Oct-2020, 19:08
I installed the new update and created/downloaded/installed a fresh config. Both went without any problems.
Steps taken:
- download the firmware update and extract it
- power down the dev and remove the power chord
- switch the SD card from the dev to the pc
- remove the config (copy it to the PC ) so the SD card is empty
- copy all the firmware files to the root directory of the SD
- put the SD back in the dev
- power up and let the dev install the firmware until you get the msg 'press front button'
- after cycling, power down, remove SD
- either create and download a fresh config or copy the 'old' config back to the sd
NOTE: I was able to create a fresh config on the website and download it to the PC
- re-insert the SD into the Dev and power up
I had zero problems with the above approach.
Steps taken:
- download the firmware update and extract it
- power down the dev and remove the power chord
- switch the SD card from the dev to the pc
- remove the config (copy it to the PC ) so the SD card is empty
- copy all the firmware files to the root directory of the SD
- put the SD back in the dev
- power up and let the dev install the firmware until you get the msg 'press front button'
- after cycling, power down, remove SD
- either create and download a fresh config or copy the 'old' config back to the sd
NOTE: I was able to create a fresh config on the website and download it to the PC
- re-insert the SD into the Dev and power up
I had zero problems with the above approach.