Sweet Room

[ogs]

So, after deactivating the SAM profile and high-pass, I gave it another try.

But after measuring again, I noticed, that the results are still not quite as expected.
For creating the EQ bands I measured left and right speaker with REW independently.
So I have different EQ values for left and right speaker in the eq.txt file and copied it to both amps.
The measurement with 'Main' EQ active showed, that for the left speaker the filter bands of the right speaker have been applied. For the right speaker the correct filters were applied.
I also tried to copy the eq.txt containing only the values for the left channel on the SD-card of the Master, leaving the EQ values for the right channel to 0. I did the same for the companion and only inserted the values for the right channel (I think I read this somewhere on the Devialet support page for Sweet Room).
But like this, no filter for the left speaker was applied at all. For the right speaker it worked correctly again.

Did anyone else with dual mono setup measure the left and right speaker seperately for creating the filter bands and also noticed after re-measuring the results, that the wrong EQ filters of the right channel were applied to the left channel (respectively Master unit)?

I might try it again filling the filter values in the 'Alternate' EQ an see if this works, but gradually I'm getting annoyed with this (already have spent two days with measuring, filter creating, SD-Card switching, re-measuring, ...).

If I read this right you need to put the left channel EQ in both R and L for the companion eq.txt to make it work (maybe you've already tried this). Does it help to link the two amps with a trigger cable?
Anyway, it should work by putting the same eq.txt on both SD cards (with different settings for L and R) so this is clearly a bug.