05-Dec-2020, 01:55
(04-Dec-2020, 18:28)alandbush Wrote:(04-Dec-2020, 16:16)tategoi Wrote: I read that the Q value should not be more than 10. My Q goes as high as 35. I have yet to figure out if there is a way to limit the Q value when performing the EQ in REW. If anyone knows please advise.
Try the REW equaliser help page, specifically the 'Filter tasks' section.
Disabling 'Allow narrow filters below 200Hz' sets Q to a maximum of 5.
However, check the accompanying description as to the effect it has on filter generation.
Ps - I would like to view your measurement. Would you be prepared to attach the .mdat measurement file?
Pops - I note that filters 5 and 6 are ignored. I presume that's the known bug resulting from the conflict of SAM with Sweet Room.
Thanks for the tips and link to the help page, I will refer to it when I do the next EQ.
I read that filters after 5 are ignored, but from the charts it look like only filters 1-4 are applied as there is no correction on frequencies above 100 Hz.
I cannot attach the .mdat file here. Perhaps I will send you separately.
Technics SL-1200G | Ortofon Cadenza Bronze | Audio Technica AT-ART9 | Hana ML
Nucleus+ | Melco N1ZS/2EX | D100 | S100 | Telegärtner M12 | Accustic Arts Drive II
Devialet Original d'Atelier | Vivid Audio G3 Giya
Gold Phantom Opéra de Paris
S I N G A P O R E