Firmware 2.13.1 - What changes?

[Taucher669]

Hello,
I just have updated my 4 Phantom Golds to the FW 2.13.1 which was successful.
Now I got a problem that the usual way to enter standby mode does not seem to work anymore and the 4 Phantoms are heating like crazy - they become even hotter than usual. Could you please advise HOW to enter now standby mode? I have tried short press - long press on the rear button but the only thing that happened was that I lost configuration on one pair - seems I have resetted it by pressing long the button.


Kind regards,
Peter

I have to come back to my own post here with some new findings:
Most important - strong temperature raise has come down to normal levels after some time. Explaination could be that the subjective temperature which can be felt outside at the hetsink might be delayed ... It seems that the head (processor load) during the update process and thereafter (clean-up?) is higher than normal and this will come down after some 30 minutes or so. I have written the post right after the update ... so ... they were still hot

Standby Mode: Back working. Here it seems that right after the update it is not advised to play around with standby mode. I have then tried after around an hour of playing music and when I finished listening and tried again long pressing the button (5 sec or so) did the job and they went to sleep as before. Short press will wake them up - so at the end all good as before.

I just tested feeding the eggs with heavy stuff aka MQA 192kHz via the following signal chain:

Tidal - connected to ROON - WIFI -  Bluesound Node II - optical - Devialet DIALOG - Ethernet - 2 linked Stereo Pairs of Phantom I Gold

This works perfectly with no hickups and perfect synch: ROON sends unfold MQA via RAAT to Node II - Node II is rendering MQA and sending uncompressed and enriched MQA signal at 192kHZ via Optical to DIALOG - DIALOG is distributing it to the 4 Golds