21-Feb-2015, 09:50
Misterpete,
I would plug your CD into "Dig 4", your SQB into Dig 3. You would be using the D's onboard DAC.
Digital 1 and 2 can be configured as pre-outs. On the configurator enable Dig 1 and 2, then hover your cursor under where it says Digital till a "Settings" heading pops up. Left click and you are into settings, where you want to configure Dig 1 and 2 as preamplified output (stereo) unless of course you are using 2 subs when you would select preamplified output mono.
Once you have selected the way you want to configure the digital inputs/outputs, further options will appear.
It sounds like you have a REL sub. Please check with Devialet if it is OK to connect your sub via the speaker outputs. I'm fairly sure that this would be OK but since I have no experience of this, please make it 100% certain.
I have also been told (by a REL technical guy, Kevin) that you can connect their subs at the speaker end as well. But, again, please check this as Kevin and I may have misunderstood each other.
So, if all is well with connecting your sub via speaker level, this leaves you free to configure Dig 1 and 2 as headphone output (don't forget to also reconfigure the remote so that mute only applies to your speakers and not also to the pre-amp out), which means that you would not need to use 2 seperate configurations and all should be sweet.
BTW I also suffered buyers remorse in my early days of D ownership but now you would need to pry it out of my cold dead hands.
Good luck.
I would plug your CD into "Dig 4", your SQB into Dig 3. You would be using the D's onboard DAC.
Digital 1 and 2 can be configured as pre-outs. On the configurator enable Dig 1 and 2, then hover your cursor under where it says Digital till a "Settings" heading pops up. Left click and you are into settings, where you want to configure Dig 1 and 2 as preamplified output (stereo) unless of course you are using 2 subs when you would select preamplified output mono.
Once you have selected the way you want to configure the digital inputs/outputs, further options will appear.
It sounds like you have a REL sub. Please check with Devialet if it is OK to connect your sub via the speaker outputs. I'm fairly sure that this would be OK but since I have no experience of this, please make it 100% certain.
I have also been told (by a REL technical guy, Kevin) that you can connect their subs at the speaker end as well. But, again, please check this as Kevin and I may have misunderstood each other.
So, if all is well with connecting your sub via speaker level, this leaves you free to configure Dig 1 and 2 as headphone output (don't forget to also reconfigure the remote so that mute only applies to your speakers and not also to the pre-amp out), which means that you would not need to use 2 seperate configurations and all should be sweet.
BTW I also suffered buyers remorse in my early days of D ownership but now you would need to pry it out of my cold dead hands.
Good luck.
D200, Magico S1's, Antipodes DX
