Power consumption

[deviousalet]

Following the suggestion in another thread (http://devialetchat.com/showthread.php?tid=1906) I connected the 3.5mm trigger cable between my D400 master and slave, configured an input on the slave (digital in my case), and then low and behold I measure lower power consumption. Where previously my D400 used 28W "off", 33W in standby, 53W idle it now uses 18W "off", 22W in standby, 53W idle. So this tip is saving me from wasting 10W "off" and 11W in standby at no cost. The temperatures also dropped and are the same for the master and slave (they used to differ slightly). So it look like linking the units via the trigger cable lets them communicate more effectively. This seems like an impressive return for such a minor configuration tweak. I've asked Devialet to add this to their setup instructions.