Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Devialet RS232 Control Utility
#17
(12-Jan-2017, 04:31)JohnnySix Wrote: My USB-serial cable has lights that flicker when rs232 traffic goes through it. Mode tick boxes in Configurator are not essential just for sending a command.
Beware that commands are very much Case Sensitive.

Well, my ip2sl device also has lights that Flicker whenever a command is received via telnet. Normally, this implies that the serial interface forwards it to the Devialet.

 And it does flicker when I was sending commands like [DEVIALET>POWER=!] but nothing happens on Devialet and also there is no error message coming back.

I would need to see if devialet receives a signal at all in order to be sure that the cable is not working.

Maybe am using the wrong command?

Any other ideas? Is there a way of "pinging"?
Reply


Messages In This Thread
Devialet RS232 Control Utility - by JohnnySix - 20-Aug-2014, 19:22
RE: Devialet RS232 Control Utility - by Martyn - 19-Dec-2014, 13:29
RE: Devialet RS232 Control Utility - by k1282 - 10-Jan-2017, 12:28
RE: Devialet RS232 Control Utility - by k1282 - 11-Jan-2017, 14:03
RE: Devialet RS232 Control Utility - by k1282 - 11-Jan-2017, 14:45
RE: Devialet RS232 Control Utility - by k1282 - 12-Jan-2017, 00:08
RE: Devialet RS232 Control Utility - by k1282 - 12-Jan-2017, 10:34
Devialet RS232 Control Utility - by no32 - 12-Jan-2017, 05:41
RE: Devialet RS232 Control Utility - by k1282 - 12-Jan-2017, 22:50
RE: Devialet RS232 Control Utility - by k1282 - 18-Jan-2017, 19:08

Forum Jump:


Users browsing this thread: 1 Guest(s)