As I'm sure you already know there can be too much silver where things get a little bright. That's why I tone it down with a bit of Rhodium scattered about. Even my existing speaker cables do use Rhodium CF series bananas at each end with the previously mentioned WBT's. Additionally the 3% gold content in the CC's goes a long way preventing brightness. In one case a year or so back on a previous piece of equipment I had to throw in one lowly Gold plated FI-50 15A IEC as it got sickenlngly sweet/bright. Warmed it right up! YMMV and there's lots of work-arounds if it goes a little too far. Amazingly you can also fine-tune things at the component level with power cords using rhodium/gold AC plugs and IEC's which I find much more predictable/repeatable than jumping on the high-end cable-go-round. Lots of ways to skin these cats! And power cords seem more closely related to "an ounce of prevention" whereas interconnects more closely address the "pound of cure."
Statements in my posts are opinion only, not to be construed as fact. Any projects I engage in are at my own risk! Their outcome cannot be assured and may result in success, small/no change or catastrophic failure. I encourage no one rely on anything I say or do as gospel and to realize your mileage may vary!
