I don't think that one's going to work either. The PDF specification shows the threaded body/spade to be a one-piece design that's 7.3mm too long to fit. If you remove 7.3mm of spade to bring OAL back into specification there won't be enough spade length remaining (1.7mm) to engage the female clamping receivers in the Devialet and the threaded barrel will be butting up against the clamping receivers before the small remaining spade could fully seat inside them.
Here's the link. Take a look at the pic in above right of page then the physical specifications below. Sorry to be the messenger on this.
http://www.vhaudio.com/furutech-ft-809-cutout.pdf
Here's the link. Take a look at the pic in above right of page then the physical specifications below. Sorry to be the messenger on this.
http://www.vhaudio.com/furutech-ft-809-cutout.pdf
Statements in my posts are opinion only, not to be construed as fact. Any projects I engage in are at my own risk! Their outcome cannot be assured and may result in success, small/no change or catastrophic failure. I encourage no one rely on anything I say or do as gospel and to realize your mileage may vary!
